Product Overview
Microcontroller: For ATMEGA328P
Digital I/O Pins: 14 (6 of which provide PWM output)
PWM Digital I/O Pins: 6
Analog Input Pins: 6
DC Current of Each I/O Pin: 20 mA
DC Current of 3.3v Pin: 50 mA
Flash Memory: 32 KB (for ATmega328P), 0.5 KB of which is used by the boot and interception program
SRAM: 2 KB (for ATmega328P)
EEPROM: 1 KB (for ATmega328P)
Clock Speed: 16 MHz
LED-BUILTIN: 13
Features
1、Includes for ELEGOO R3 controller board and USB cable, 100% compatible with for IDE Official R3 official kit
2、Basic starter kit is suitable for beginners to learn programming, can assist in learning all the resources of the for R3 development board
3、This product is a very good choice, because the designer holds an open attitude and discloses all design schematics and procedures
4、DIY starter kit is suitable for school education and laboratory, very practical and helpful
5、Contains accessories such as breadboards, connecting wires, potentiometers, LEDs, resistors, etc., to facilitate learning and installation
Package List
1 x For R3 Development Board
1 x Breadboard
1 x Jump Wire
1 x USB Cable
1 x Battery Connection Line
1 x Pin Header
6 x Potentiometer
6 x Keycap
15 x LED
10 x Thin Film Resistor 220
10 x Thin Film Resistor 1k
10 x Thin Film Resistor 10k
10 x Thin Film Resistance 100k
3 x Photoresistor
Package Weight and Dimension
| Weight | 0.66 lb |
| Width | 5.85 Inch |
| Height | 1.95 Inch |
| Length | 7.8 Inch |
