Product Overview
Material: ABS
Power Supply: DC24V
Installation Method: Standard rail + flat screw fixation
Product Use: Used to measure AC current, especially for power frequency 50Hz sine wave AC current
Rated Current: AC0-100A
Rated Output: DC4-20mA
Accuracy: 0.5%
Overload Capacity: 30 Times the nominal input
Temperature Drift: ≤500PPM/℃
Linearity: 0.1%
Frequency Bandwidth: 20-5KHz
Current Consumption: <15mA+ output current
Response Time: <200ms
Working Temperature: -109℃~+70℃
Storage Temperature: 25℃~85℃
Features
1、Hall‑type current conversion, which can withstand 30 times the nominal input, prevents instantaneous high current access and burns out the internal components of the sensor. The measurement circuit is isolated from the incoming signal
2、Isolate the detection signal and the output signal, effectively filter the noise in the signal, which will greatly improve the signal‑to‑noise ratio and signal stability of the product, and effectively enhance the product's anti‑interference ability
3、The primary and secondary sides of the hole current transmitter are highly insulated and isolated, which bring high accuracy, small size, low power consumption, wide frequency response, and anti‑interference
4、No insertion loss because of erforated input, fixed with standard guide rail and flat screws, easy to install
5、Especially suitable for load current intelligent monitoring systems such as generators, motors, intelligent low‑voltage power distribution cabinets, air conditioners, fans, street lamps, power grid monitoring, motor signal monitoring, railway system signal monitoring industries
Package List
1 x AC Current Transmitter
Package Weight and Dimension
| Weight | 0.66 lb |
| Width | 3.12 Inch |
| Height | 1.17 Inch |
| Length | 5.07 Inch |
