Servo Gear Box M4 Thread Hole Great Accuracy Dual Double Mode 2:1 External Gear Ratio Servo Steering Gear Box

Item Type: Servo Gear Box
Material: Aluminum Alloy, Brass
Voltage Range: 4.8V-6V
Maximum Travel: 3.92 Rotations (1413˚)
Maximum PWM Range: 600-2400 Microseconds
No Load Speed (6.0V) : 0.47 Sec/60˚ (128˚/Sec)
Stall Torsion(6.0V) : 26.4 Kg/Cm (366 Oz)
Direction: Counterclockwise Increasing PWM Signal
Movement Per Microsecond: 0.79˚/μsec

Features

1、M4 Threaded Holes: The servo gear box has M4 threaded holes on each side of the load bearing and pad gear box, and the top clamping hub has M4 threaded holes with 8mm distance grid hole design.
2、Feedback and Continuous Modes: The servo gear box uses a dual mode servo drive, where your signal controls the position in feedback mode. In continuous mode, your signal controls speed and direction.
3、Isolation and Torsion: The servo gear box isolates the axial load from the output spline shaft to slow down the rudder, but multiply the torsion of the output shaft.
4、All Aluminum Frame: The servo gear box uses an all aluminum frame to act as a mounting fixing bracket, and the steel hub output shaft is mounted in a pair of bearings for smoothing rotation.
5、External Gear Ratio: The servo gear box uses a 2:1 external gear ratio to bring torsion and accuracy up. The 8 mm hex hole of the hub shaft can drive 8 mm hex shafts or can be used to pass cables, wires, shafts.

Package List

1 x Servo Gear Box